MEP SHARK 281

SHARK tape manual sawing machine for cutting 281, from 0° to 60° left, built in manual and CCS (Cut Control System). In this version the sawing machine can single cuts without operator, using the weight of the head is controlled by a spring and a hydraulic brake. in versions BUT (with pneumatic Vice) clamp opening/closing is carried out with manual control valve (optional with foot pedals). some features : Switchboard (wiring totally identifiable, standby switch with lockable door lock device, speed switch, emergency motor magneto-thermal overload device, minimum voltage coil, phase failure protection, hi-low voltage 24 Volt) IP55 control handle Grip with locking lever hydraulic Transducer to view quick. stringing Ribbon. electric pump for belt lubrication. wire chip brush double spring for the recall of the head section chrome steel rod cut to size , with millimetre scale engraved and groomed full roll bar supports Arm tipper. , designed for installation of load platforms. bimetal band for profiles and solid pieces. Keys, instruction manual and replacement parts. the device may be provided as optional kit to install CCS on machines already produced.

Mep Shark 282 bandsaw Make Mep