Trumpf - Controlled Hydraulic Press Brake
Model TRUMABEND V 85
max. 85 to
Working width, max. 2.050 mm
Working width between columns 1,750 mm
Side daylight of each column 410 mm
Max. distance between upper and lower tool holder w/o tools 350 mm
Adjustment of upper tool holder approx. 300 mm
Table width approx 105 mm
Height of Table from floor approx. 1.050 mm
Max. stroke 215 mm
Stroke, bending speed 1 - 10 mm/sec
Stroke, rapid traverse 200/135 mm/sec
Adjustment range of back gauge, approx. 800 x 300 (vertical) mm
Accessories / Special Features:
* TRUMPF CNC Control model DELEM Type DA 65 T with 6 controllable Axis like:
Y1, Y2, X, R, Z1 a. Z 2, with direct programming of bending cycles on the pendant Control and screen with grafics.
* CNC-Controlled Cambering by the Control System
* Two-handed release on control stand, and/or foot switch.
* Pneumatic fast clamping of upper and lower tools
* 3 back gauges with finger gauges and micrometer gauges
* Pressure Manometer for the Hydraulic System
* In front of machine there are 2 crosswise adjustable sheet metal supports.
* Various Bending tools smaller size, Safety
the machine is right now not working, because there is an PILZ electronic safety unit faulty.
It is basically in very good condition, but right now it is not working because there is a electronic component (like a electronic safety modul) defect. And this stops the whole machine.
Please note that this description may have been translated automatically. Contact us for further information. The information of this classified ad are only indicative. Exapro recommends to check the details with the seller before a purchase