Type: Dividing line
Year of production / SO / GO: 2016 / - / -
The line consists of several components that form a single technological unit:
Unwinder, Divider, Hydraulic trolleys, Pneumatic hydraulic straightener, Winder, Hydraulic unit, Waste winders, Set of knives and washers.
The device parameters are as follows:
Unwinder: Load capacity 10,000Kg, Max. the width of the input material is 1550mm, inner diameter 450-750mm
Development is performed with the help of an electric motor
Shears for longitudinal cutting:
It is a machine set of two shafts on which knives and washers are threaded according to needs
The hardness of knives for longitudinal cutting is 58-60HRC, The knives are in the number of 26 sets of two pieces of 16mm knives + 48 rubberized pads
The cutting speed is 10-35m / min. Divisible material from 0.3 - 3mm, Minimum cutting width is 16mm
Pneumatic hydraulic straightener:
Operating pressure 8bar, Max. operating width is 1550mm
Load capacity 10,000Kg, Controlled by electric motor 11KW, inner diameter of the coil is 508mm
Allows traffic control in automatic and manual mode.
Our line has been in operation since June 2016 and has so far processed only about 100 tons of material in trial operation. The expected daily capacity was including the handling of 32 tons of material.
Basically, only a test series was worked on the machine ...
Please note that this description may have been translated automatically. Contact us for further information. The information of this classified ad are only indicative. Exapro recommends to check the details with the seller before a purchase