Tecomelt plastic injector
Model: ES 7050/450 H K TM
Year of manufacture: 2000
TECOMELT 450 ton thermoplastic injector with 4600 cm3 injection capacity. Engel ERC Cartesian Servo Electric Robot.
With ENGEL tecomelt you can mold injection elements in an especially efficient, careful and cost-effective way:
- Wide variety of uses - rear injection of linings for pillars, doors, interiors of trunks, etc.
- Single stage process - low pressure injection molding machine for molding, by a single operation, the component and mounting details, as well as the decorative fabric.
- Perfectly combinable - ideal to combine with delicate fabrics and sheets.
- Careful procedure - multipoint casting system with cascade control.
EC 100 control, Spanish language. KEBA control.
1000 hours of operation.
120 mm screw. 20 LD. Bimetallic M3 for soft PVC. Toe closure with needle.
Injection capacity: 4600 cm3. 4300 grs (soft PVC).
TECOMELT low pressure injection pressure.
Plates size: 1670x1670 mm.
Measures between tie-bars: 1250x1250 mm.
Knee closure: 5 points.
Max / min mold: 890/300 mm.
Opening stroke: 700 mm.
Extractor: 240 mm, 114 kN.
Installed power: 90 kW.
3 noyos mobile plate
16 heating zones.
1 air valve
Stainless steel hopper
Measures of the machine without robot: 9480x2592x2485 mm.
Weight without robot: 45 tons.
Robot ENGEL ERC 83/1-C. Servoelectric X axis: 1300 mm; Y axis: 1700 mm; Z axis: 2320 mm. Axis C: 0-90º.
Robot, EMS and Teleservice interface.
Instruction book, key, 3.5 'disk drive, and machine floppy disk.
Please note that this description may have been translated automatically. Contact us for further information. The information of this classified ad are only indicative. Exapro recommends to check the details with the seller before a purchase