This machine is in perfect condition for its age, was regularly maintained and is at CE norms. It is located in a large automotive factory but was working on and off according to production plans (no regular shifts, no intensive production).
It will stop producing at the middle of July and can be collected then After that, the machine will be moved to a new location but will no longer be visible under power.
The machine is equipped with two injection units, after agreement it is possible to sell an internal parts conveyor with the machine.
Type of material used:
Horizontal : PP T40 *** PC *** TPE *** PC/ABS
Vertical: TPE *** PA6 T30
Screw diameter: 25 + 25mm
Injection weight: 45 + 45g
Injection volume: 54 + 54cm³
5.2019 – Overseal injection. hydraulic motor units and switchgear
2.2018 – Electrical repair engine, pump overhaul, oil change
4.2017 – Machine calibration
4.2016 – Replacement of the auger tip
5.2014 – Replacement of the floppy disk drive with a CF card reader
5.2014 – Sealing of the upper unit
4.2013 – Machine calibration
1.2013 – retrofitting of the machine with pneumatic control of the mold nozzles
1. 2012 – Replace card 201 440, replace auger and tip
4.2009 – Machine calibration
3.2008 – Ejector resealing
1.2006 – Machine calibration
12.2004 – Calibration of the machine
Please note that this description may have been translated automatically. Contact us for further information. The information of this classified ad are only indicative. Exapro recommends to check the details with the seller before a purchase