Sorry, this offer is no longer available on Exapro

POLAR 137 XT-AT Paper guillotine

Here is a selection of similar machines

cutting machine Polar 137 XT-AT
age 2004 approx. 795.000 cuts
XT-Touch controller
working width 137cm
self diagnostic system
waste removal Autotrim (bay on the table to place a container below
or for a connection to a suction, needs to be connected to an
existing pressure connection)
automatic pressure adjustment (special option)
chromed air table 100x100 with delivery left side and chromed air table 100x80 right side
3 HHS knifes

with CompucutP-Net Connect Software inclusive 1 P-Net Client
for connection to an Polar X Model
software service for external cutting program management
consists of:
- interface card for cutting machine
- installation disc

Software needs to installed on an existing PC, this computer
needs to be connected with the workflow but also with the cutting machine

good condition!

Please note that this description may have been translated automatically. Contact us for further information. The information of this classified ad are only indicative. Exapro recommends to check the details with the seller before a purchase

Opening in cm 137
-------------------
Worked hours
Hours under power
State good
At local norms ---------
Status
Datasheet Polar 137 XT-AT
Client type Reseller
Active since 2014
Offers online 60
Last activity March 28, 2024

Description

cutting machine Polar 137 XT-AT
age 2004 approx. 795.000 cuts
XT-Touch controller
working width 137cm
self diagnostic system
waste removal Autotrim (bay on the table to place a container below
or for a connection to a suction, needs to be connected to an
existing pressure connection)
automatic pressure adjustment (special option)
chromed air table 100x100 with delivery left side and chromed air table 100x80 right side
3 HHS knifes

with CompucutP-Net Connect Software inclusive 1 P-Net Client
for connection to an Polar X Model
software service for external cutting program management
consists of:
- interface card for cutting machine
- installation disc

Software needs to installed on an existing PC, this computer
needs to be connected with the workflow but also with the cutting machine

good condition!

Please note that this description may have been translated automatically. Contact us for further information. The information of this classified ad are only indicative. Exapro recommends to check the details with the seller before a purchase


Specifications

Opening in cm 137
-------------------
Worked hours
Hours under power
State good
At local norms ---------
Status

About this seller

Client type Reseller
Active since 2014
Offers online 60
Last activity March 28, 2024